Windows-cleaning robot is mainly based on its bottom vacuum pump or fan device, firmly attached to the glass. It then uses artificial intelligence to automatically detect the window's edge distance, to plan the window cleaning path (from left to right, or from bottom to top), and to return to the initial location after cleaning for easy removal.
Windows-cleaning robots usually use the force of their adsorption on the glass to drive the bottom of the fuselage to wipe off the dirt on the glass. Window cleaning robot is not many kinds of market, the principle is roughly the same. The Cobos robot was first developed, probably in 2011.
Early window-cleaning robots could only be adsorbed on flat, smooth glass surfaces. That is to say, early designers had more requirements for the adsorbed glass medium in order to ensure the robustness of the robot. The requirement for the adsorption medium becomes much more relaxed.
The first type: Vacuum sucker adsorption.
The double-layer vacuum sucker can remove the air from the bottom through the internal vacuum pump and form a certain vacuum environment so that the window cleaning robot can adsorb on the glass. The adsorption principle requires the medium to be flat and has no obvious protruding obstacles, and is only used on the glass surface.
The second type: Fan adsorption
The window cleaning robot adsorbed by the fan through the inside fan forms the air pressure difference inside and outside, and then adsorbs on the glass. This adsorption principle requires a slightly wider medium, as long as the surface of the medium is flat (except for glass surfaces, such as glass with stickers, grinding glass, marble walls, tiles, etc.).
Matters need attention
1.Before using, be sure to fasten the safety rope and tie it to the fixtures in the house.
2.Before use, please check whether the safety rope is damaged, and whether the knot is loose.
3.Glass doors and windows without balcony must be set up danger warning area on the ground floor.
4.The machine has a strong magnet, be careful not to close to the magnetic card or magnetic recording device.